Lutron Electronics LCP128 Manual de usuario descargar pdf (Pagina 12)

12 Installation Guide for Dimming and Switching Panels

Feed-Through Panel: Feed and Load Wiring (all voltages)

SH1

SH2

SH3

SH4

To distribution

panel

Load

Neutral

Hot/live

Switched

hot/live

Dimmed hot/live

Hot/Live

Neutral

Load

4-Circuit Dimming Module (4U)

4-Circuit Adaptive Dimming Module (4A)

4-Circuit ELV Dimming Module (4E: 230 V and 220-240 V only)

4-Circuit Quiet Fan Speed Module (4FSQ)

4-Circuit Switching (Relay) Module (XP)

Bypass jumper

Bypass

jumper

Feed

TVM Module

For 0-10 V, PWM, Tridonic® DSI, and DALI loads. Each TVM

controls two consecutive circuits of lighting and are the first

circuits in the panel. Maximum low-voltage ballast control

current: 50 mA per zone, 750 mA per panel. Dimming or

switching module is used to switch power to the ballast.

+ 1 –

+ 2 –

H/L

–

Ballast

Neutral

Hot/Live

Dimmed hot/live

TVM

General Notes

• Typical dimming/switching legs shown.

• Do not remove bypass jumpers until after load wiring has been verified.

Wire sizes for power feed, to each input

• Power feed: #14 AWG (2.5 mm

) to #10 AWG (4.0 mm

)

• Neutral feed: #14 AWG (2.5 mm

) to #10 AWG (4.0 mm

)

Wire sizes for load wiring, from each output

• Dimmed hot (live): #14 AWG (2.5 mm

) to #10 AWG (4.0 mm

)

• Load neutral: #14 AWG (2.5 mm

) to #10 AWG (4.0 mm

)

Control Circuit Power

• Supplies power for internal operation.

• Requires dedicated feed with same voltage and phase as panel.

• Must be 1/4 in. (6 mm) away from PELV (Class 2: USA) control wiring

harness.

• Panel voltage (see pages 2-3) indicates feed voltage.

• For 230 V and 240 V panels, “Hot” is referred to as “Live”.

Therefore, terminals will be labeled L and DL.

See terminal block

modules for

specific wiring

details.

Circuit breaker

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

Lutron Electronics LCP128 Manual de usuario Pagina 12

Comentarios a estos manuales